Briggs & Stratton 33S877-0019-G1 Intek Series 19 HP 540cc Single Cylinder Engine
This genuine Briggs & Stratton Professional series 540 cc single cylinder engine offers dependable power for your equipment needs. With a power rating of 19 horsepower, this engine features a premium Dual Clean air filtration system, electric starter, and maintenance-free Magnetron electronic ignition. With a manufacturer limited warranty of 2 years consumer use / 1
This genuine Briggs & Stratton Professional series 540 cc single cylinder engine offers dependable power for your equipment needs. With a power rating of 19 horsepower, this engine features a premium Dual Clean air filtration system, electric starter, and maintenance-free Magnetron electronic ignition. With a manufacturer limited warranty of 2 years consumer use / 1 year commercial use, Briggs & Stratton provides power that you can trust. This engine includes a Dura-Bore cast iron cylinder sleeve for extended life. This engine includes an installed muffler. This engine includes a fuel pump. This engine includes an oil filter. This engine includes a 9 amp charging system.
https://bestelectricmower.com is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to ("" (amazon.com, endless.com, smallparts.com or myhabit.com). |
Re-engine of Rear Engine Lawn Mower Engine was fairly straight forward and installation was easy for my application: re-engine of a rear engine snapper. It has a one inch non-tapered shaft that is tapped (if you need a tapped shaft, I did not) However very little supporting documents are provided with this engine, other than a operators manual, and no wiring diagram. Wiring as follows: Grey wire provides 12 volts to the carburetor solenoid (needs to be wired to the switch pole that provided 12 volts in the start and run position…
Replacement for my Craftsman YS 4500 I used this engine for a Craftsman 42 inch YS-4500 mower (917.27664). The original engine was an Intek Gold 20HP (31P977-0670-E1). It was a virtual drop in. The electrical harness and fuel lines hooked up without any modifications required. I did need to reuse the old muffler, as the one the new engine came with wouldn’t fit under the engine cowling. Not a big deal though. Disassembly of the old motor was easy enough. Four engine mounting bolts and the drive pulley bolt. But you will definitely…
Dropped this engine in my John Deere D110. Purchased this engine to replace the Briggs & Stratton on my John Deere D110. I had mowed with it for 9 years and plowed snow with it for about 5 of those years so I wasn’t too surprised when my engine blew.I’m a total amateur and removing the old engine and replacing it with the new one took me a total of 4 hours with socket wrenches, allen wrenches, and a screwdriver. There are only 4 bolts holding down the engine and then you’ll need to remove the main bolt underneath the engine…